Custom Door Bell Button
Match your doorbell to your décor or personality by designing your own door bell cover. From varied shapes and sizes to a hand hammered edging, let our artisans bring your ideas to life.
Custom Door Bell Notes
- All custom doorbells are made from 0.120″ carbon steel plate, primed, and finished in matte black.
- All custom door bells come with 2 or 4 #8 x 1/2″ pyramid head screws unless otherwise specified by the customer.
- All designs will be confirmed via email with a pdf attachment before production can begin.
- All sales are final once production begins. Bell buttons may be replaced upon request.
- Not recommended for use near salt water, stainless steel bell button can be made upon request, cost will be quoted.
- Lead time is approximately 4 weeks, we will try to get each order out as fast as possible but we cannot guarantee anything faster.
- Door Bell Chime, wiring, and transformer are not included.
Installation Instructions
- If you are unsure if your current door bell system is low voltage, please confirm with an electrician before beginning.
- Place door bell plate in the desired location and trace screw holes, predrill with a 5/32″ drill bit.
- If the space for the button is not wider than 5/8″ and 5/8″ deep you may need to trace the button hole and predrill with a 11/16″ drill bit.
- Place the push button into the plate so there is no gap between the trim and the front of the plate.
- Loosen the wiring screws on the back of the push button, wrap each wire around each screw and tighten the screws.
- Place the plate with the button back into the desired location and hand tighten screws.